X10-ONE Trail, 4 of 90° carbide: Four inches of steering carbide - more than the competition. Extra long Masterweld wear pads, plus carbide wear pads. Mild steering control. Ideal for older or smaller sleds. Fits most sleds. Not recommended for high performance sleds. Available in the following models: 108, 115, 118, 132, , 210, 246, 250, 260, 420, 428, 434, 444, 448, 460, 609, 619, 625, 630, 635, 640, and 644. X10-TWO Performance, 6 of 90° carbide: The standard of the industry. Six inches of cutting carbide, properly located. Full length Masterweld filler on the keel of the runners, plus carbide wear pads. Up to 2000 miles of wear. Available in models to fit either leaf spring or IFS sleds. z Available in the following models: 130, 246, 250, 420, 428, 430, 432, 434, 444, 446, 448, 630, 632, 634, 640, 642 and 644. X10-THREE Super wear, 7-1/2 of 90° carbide: The ultimate trail carbide for the high performance sleds. 1/2 host bar and studs are extra large. Carbide is 3/16 square, 7-1/2 long. Keel has Masterweld filler and carbide wear pads. Good for several thousand miles. Available in the following models: 122, 130, 134, 246, 250, 430, 440, 444, 448, 619, 630 and 634. X-PR1 Hi Performance, 6-1/2 of 60° carbide: Mid-range performance runner with 6-1/2 , 60° carbide in the middle, 4 carbide wear pads, 1/2 diameter bar, 3/8 x1 studs to fit over skiskins. This runner is for those riders who are looking for quicker steering than you get with 90° carbide, but something less aggressive than the very high performance X-PRT. Available in the following models: 130, 132, 134, 210, 250, 428, 440, 444, 448, 634, 635, 640, and 642. X-PRT Extreme, 8 or 9 of 60° carbide: High end performance carbide runner with 9 , 60° carbide in the middle, 1/2 diameter bar, 1 long bolts and four wear pads for durability. Designed for the rider who needs 200-300 studs to hook up, and then can t get around the corner. The X-PRT runners feature the largest carbide in the industry - up to 50% longer wear. 8 Available in the following models: 130, 250, 430, 444, 448, 642 and 644. 9 Available in the following models: 115, 118, 420, 428, 432, 434, 440, 619, 630, 634 and 640. SX RACERS, 10 carbide: ***ISR LEGAL for ALL SNOWCROSS CIRCUITS*** Full profile 1/2 round host bar. 10 of XPR carbide. Unique design for more aggressive steering. Proper length bolts for easy installation. Extra hole may need to be drilled in some skis for the added rigidity needed with carbide runners.
